Set technical data with batcher?

[DarkStar]

I'm trying to set image technical metadata with the batcher, but I can't seem to figure it out. I want to set the focal length, but this could probably apply to any of the fields.

So far, I have done:

• * Create a batch
  * Add a "Image Details" step
  * Expand the "Technical" drop-down list
  * Click the little circle and check "Replace Content"

After this, however, I can't figure out where to actually set/pick the new value. Currently, it just defaults to 0.0 mm.

[Hert]

You can't set technical metadata. This is supposed to be written by your image recording device.

You could use tools like ExifTool to edit these fields for your images.

Hert

[DarkStar]

Thanks. I'll look into that.

As a feature request, it might be worth removing the selection circles for read-only fields.