Version set down arrow not appearing

[peterpix]

For some reason the down arrow to scroll down through tabs for versions beyond version 6 is missing. I think it might be hiding behind the version 6 tag, as I can just see a bit of the down arrow, but can't click it.

I'm attaching an example of a version set which has 9 versions, but only 6 tags are showing and there is no down arrow (or just the edges, that I can't click).

This is happening now for all of my version sets. Previously the arrow was below the last version tag that was visible, so I could click it and the tabs would scroll, so I could access higher tags.

Is there a setting that can be used to correct this?

Peter

[G8DHE]

Muhh I think i might be suffering this as well!

[jstartin]

Here too, with 2032 on Windows. With careful examination just the very tip of the arrow is visible/available at the bottom right of the tab for version 6 with the view at 100%. Actually clicking in the right place is very hit and miss but can work (got it just once after much trying). Expanding to 300% gives a usable arrow but other display weirdness which vanishes after clicking the arrow.
I think this is a bug that should be reported on Mantis.

[G8DHE]

Reported https://mantis.idimager.com/view.php?id=3353

[peterpix]

g8dhe you beat me to it but I didn't know as we posted bug reports almost simultaneouly, so now there are two bug reports. Oh well!

[Hert]

You can download build 2077 from the website now (no web update signal). Install it over your existing version. Please let me know if that fixed this. Thank you

[peterpix]

Hert, thanks.

Not sure what to download - the trial?

Peter

[peterpix]

If it's the trial, I had a look at it (began to run the installer) and it's not clear whether it has the facility to install to a drive other than the default, which I assume is C. My current installation is on my D drive (as my C drive SSD is perilously full). I didn't dare click Install in case it just installed and was the wrong version. Does if offer the ability to install on a different drive after you click install? If not should I uninstall the current installation from the D drive?

Peter

[G8DHE]

Yes, thanks working here fine.

[peterpix]

Geoff, where did you get your installer from?

Peter

[Hert]

There’s only one installer. Download it from the website or, if you’re a licensed user, from https://cp.idimager.com (same link as that from the website) and install it over your existing copy.

[peterpix]

Geoff, I didn't know where to log in, so thanks for that link.

Hert, like Geoff this works for me. Nice to get my full versions back.

Peter

[jstartin]

The arrow problem is fixed for a 100% view. At other view magnifications various odd things happen to the tabs, sometimes obscuring the arrow again. I suppose a new mantis entry is in order.